MINING PRODUCTS
LANOLIN PROTECT
RECOMMENDED APPLICATIONS MARINE COATING Benefits
PROTECT
Hull protection: Pirtek Protect is not and has no anti-foul qualities, but will reduce water drag factors An ideal marine coating because of its proven ability to resist acid etching, i.e. barnacles. Subsequent re-application requires no special hull treatment such as sanding/grinding etc. Slipway or hardstand time is reduced due to the saving in preparation and spray application time Virtually eliminates electrolysis – a little spray will stop this expensive killer Drastically reduces bacterial attachments, thereby saving our waterways from the toxic cocktails caused by some traditional anti-fouls Resistant to acid etching Base metal penetration Pro-active ability Reduces hydrolysis Also good for: Outboard legs Sail Drives Bow Thrusters Stern Drives Log Spigots Intake Pick-up Grates Propellors Buoys
Preparation All equipment which has been in sea water, should first be washed down with liquid chlorine (3:1). All boat hulls must be washed down with liquid chlorine (3:1) to kill any microscopic spore. Fibreglass hulls: For new or previously untreated hulls a Gelcote sealer should be applied if one has not been applied previously, prior to applying Pirtek Protect. The surface must be CLEAN and DRY. Pirtek Protect should not affect the Gelcote sealer used on fibreglass hulls and there have been no reported instances were Pirtek Protect has reacted with a Gelcote sealer coating. If you are unsure about applying Pirtek Protect it is recommended that an inconspicuous section be coated to test for reactivity. If reaction occurs please do not apply Pirtek Protect. Aluminium hulls: The surface must be CLEAN and DRY. If heavy oxidation exists, remove with aluminium cleaner, and then apply Pirtek Protect. Previously anti-fouled hulls: Remove marine growth and loose anti-foul particles thoroughly. Surface must be CLEAN and DRY before application of our Pirtek Protect Propellors: Clean propellor or fitting back to base metal and wash with a liquid pool chlorine at 3:1 ratio to kill any microscopic spore. (very important)
Application Pirtek Protect Coating can be applied by: (a) Sprays (including airless) (b) Roller or brush Generally 1 or 2 coats are sufficient. Always allow evaporation time between coats and before launching. Remember Protect always remains tacky until submerged Propellors: It is preferable to heat the metal to between 65°C to 100°C. Liberally apply Pirtek Protect Grease directly onto the hot components and rub in where practical.
Re-application Clean off with steam cleaner or hot pressure wash. Surface may be cleaned by using Surface Prep or by hand scrubbing with hot water above 60°C. When CLEAN and DRY, re-apply as per instructions
Maintenance All moored hulls MUST be visually inspected, and the hull wiped down every 4– 6 weeks if required.
148
U
This page is part of a complete catalogue containing technical and safety data. All data must be reviewed when selecting a product. Pirtek reserve the right to change technical specifications without notice