OPERATION
...............................................................................................................................................................................................................
Setting or resetting totalizers
48
+ Vb 00000242.56 Vm 00000065.10 VO 00000000.00 VbD 00000065.10 VmD 00000000.25 < TOT PTZ OPER. >
m3 m3 m3 m3 m3
2. Press "¯" to reach the "Setting totalizers" line, and then press Enter to move to the next screen.
On-the-fly calibr. + Setting totalizers Totalizer mode Load limits < TOT PTZ OPER.
>
Set VmL Set Vb Set Vm Set VO < TOT PTZ OPER.
1. In the "Totalizers" ("TOT") book, press Enter in any line to reach the next chapter.
0 0 0 0 >
3. Now use "¯" to select the totalizer to be set and press Enter. You can set the Vb totalizer if you have entered a calibration code (C1, C2 or C3) and set the calibration switch to its "input" position (see figure on page 38). To set the Vm and VO totalizers, it is sufficient to use one of the calibration codes; and one of the user codes for the customer's VmL totalizer. 4. Use the "¯" or "" key to set the desired totalizer reading digit by digit.
New value ........ ® (00000000 . . . 99999999) 15:27:44 22.04.08 < TOT PTZ OPER. >
Stop Alarm stop Reset Off Vm unit m3 Vb unit m3 Vm per MID < TOT PTZ OPER. >
5. If you select "Totalizer mode" instead of "Setting totalizers" under item 2, you will reach the menu shown on the left. Press "¯" once and then Enter in the "Reset" line and you will reach a selection option where you can reset totalizers. Set the selection text to "Totalizers" and press Enter. All totalizers will then be set at 0. Afterwards, the selection text will automatically switch back to "Off".
............................................................................................................................................................................................................... Manual EC 900 · EN03 · 2012-03