END CLOSURE OPTIONS
Buy Online at www.mrostop.com/spring-units-c-514_547.html
LARGE PARTS WITH ALUMINUM BEAD RINGS
All of the parts that are shown with crimped bead plates are also available with bead rings. (Bead plates are not suitable for some applications.) Typical examples of where bead rings are often used follow: 1. Where parts are stacked to increase stroke (See page16).
2. Where the air spring is being used as a boot or flexible connector (See page 29).
3. When used as an Airmount isolator with an auxiliary reservoir (See page 24).
4. When air must move in or out of the unit at an extremely fast rate (and a 3/4" NPT air inlet is too small).
5. When used with an internal shaft, to either guide the part or to pull (rather than push) a load.
CONVOLUTED AIR SPRINGS (#203 is shown)
BEAD RING BOLT May be one of three varieties. See page 10. Also refer to the data sheet order block on each individual part for bolt lengths.
NUTS AND LOCKWASHERS are included with the part. (Except for socket head type bead rings).
MOUNTING PLATE is not included. See page 10 for material, machining recommendations, and installation instructions.
BEAD RING, upper and lower. (Aluminum)
GIRDLE HOOP Solid steel type shown, molded into the bellows.
BELLOWS Wall gauge is approximately 1/4". See page 5 for detailed information.
9