X
MAINTENANCE SCHEDULE Routine maintenance is necessary for all mechanized products. Periodic maintenance contributes to the product’s life span. The following maintenance chart provides guidelines for outboard maintenance and inspection scheduled to be performed by an authorized Dealer. The schedule should be adjusted according to operating conditions and use. The recommended lubricants have been formulated to protect bearings, gears and engine components. They must be used to avoid damage caused by improper lubrication. Engine Care Product
Description
Every 300 Hours or Three Years(1)
Electrical and ignition wires, inspect for wear or chafing Engine to transom mounting hardware, re-torque (40 ft. lbs.) Fasteners, inspect any loosened components Fuel and oil system components, inspect and repair leaks (2) Fuel filter, replace A
Gearcase lubricant, replace Grease fittings, lubricate (3)
B
Power trim/tilt system and fluid level, inspect Propeller shaft splines, inspect and lubricate
(3)
Spark plugs, inspect and replace if necessary
C
(2)
Starter pinion shaft, inspect and lubricate
D
Steering system, inspect and lubricate
C
Thermostats, inspect
(2)
Throttle cable, inspect and re-tension Water pump, inspect or replace if necessary
3 3 3 3 3 3 3 3 3 3 3 3 3 3 3
(1) When used in normal recreational use. Common sense dictates when using an Evinrude E-TEC outboard for commercial or other heavy use that you check these items more frequently (annual checks are recommended). (2) Emission-related component – Refer to Owner Responsibility on page 34, Product Warranty Information on page 48 and, if applicable, California Emission Control Warranty Statement on page 50 (3) Annually in salt water applications – Refer to Salt Water Lubrication Points on page 29
A. Ultra-HPF gearcase lubricant B. Power Trim/Tilt Fluid C. Triple Guard grease D. Starter Bendix Lube Only P/N 337016
35