How to configure the fast internet WAN service in Cisco Router?
In order to make sure that you can be connected to the internet at the right time and in the right way, you must be able to user the Fast Ethernet WAN interface. In Cisco routers, this interface will allow you to configure the wide area network interface in the global configuration mode. The process to do this can be quite typical. However, with the assistance of our experts at Cisco Support Australia, these steps can be taken care for in an easy and efficient way.
Steps to configure the Fast Ethernet WAN interface: 1.
You first need to enter the configuration mode for a Fast Ethernet Wan interface on the router. To exemplify, you need to enter something like the following:
eg: Router(config)# interface Fastethernet 0 Router(Config-int)#
2.
Once you have done the above, you now need to set the IP address and subnet mask for the specified interface. To exemplify:
eg: Router(Config-int)# ip Address 192.1.12.2 255.255.255.0 Router(config-int)#
3.
Use the following to enable the Ethernet interface. It wil also change its state from administratively down to administratively up. eg: Router (Config-int)3 no Shutdown Router(Config-int)#
4.
Now that you have enables the entirely of the interface, you need to exit the mode and return to the global configuration mode. eg: Router(Config-int)# exit Router (Config-int)#
These steps pertain to the single iteration of WLAN interface. If you have more than one of these, you need to apply the above steps to all of them as per your requirement.
Once you have enabled this Fast Ethernet utility, you will be able to expand upon the capabilities of the Cisco 2600 and the 1600 class of routers. If in case, the above steps are a bit too typical; for you to comprehend, you can get in touch with our experts via the toll-free Cisco support number 1 800 954 282. The experts will not just aid you in making sure that you get the best result, but you will also be able to get any of your router issues sorted out.
Original Source