The tape has to feed into the tape track on the level. The tape support table arm comes factory set but, should adjustment be needed, four adjustment screws are provided. To access the adjusting screws, the tape support table has to be removed [see machine adjusting section].
Quick fit air connector No air pipe fitted Connecting the air supply
Tape support table arm adjusting screws. Quick fit air connector with air pipe fitted
The machine is supplied with a quick fit air connector, to which you can connect your air supply. You will require an air supply that can deliver a constant minimum pressure of 7 bar. The machine is supplied with a built-in regulator that you will need to adjust to 6.5 bar once you have connected your air supply to the machine. To disconnect the coupling, hold the pipe and push toward the machine, pull back the outer ring of the connector and pull the connector from the machine. Note: No air pipe is supplied, as the length will be dependent on your installation. To adjust the air pressure, pull the cap up and rotate until the pressure on the gauge reads 6.5 bar. Once the pressure is adjusted, push the cap down. Note: It is important that the air that is supplied to the machine is clean and dry. The machine will not perform consistently if the air is dirty, as any dirt will block the valves. Wet or damp air will damage your
Air regulator gauge
Air regulator adjusting cap
Air regulator
20