REPLACEMENT OF YOUR KATCHALEAF

Regular

Replacing Your Katchaleaf

1. Attach the EZ-Roller to its anchor and position it so the Start Tag faces the water.

2. Taking hold at the Start Tag, gently pull the cover material forward through the funnel.

3. Find the anchor for the Start Tag and continue pulling the material toward that anchor. Place the Start Tag fastener in its anchor first. Continue pulling out the remaining material until the entire cover is off the roller.

4. Use the EZ-Clip tool to fasten the cover at the corners (or perceived corners) of the pool.

5. Once the corner points are in their anchors, then work outward from each corner to clip all the fasteners to their anchors.

6. The final section to be fastened will most likely be holding some water. If this section is too heavy to pull up and fasten, wait 10 minutes to allow the water to drip through the mesh.

7. If floats are provided, position the floats as desired before anchoring the remaining fasteners.

8. Once all the fasteners are anchored, the EZ-Roller can be unclipped and set aside.

Replacement When You Also Own A Katchakid Safety Net

• Refer to your Katchakid Pool Safety Net Owner’s Manual for complete instructions for replacement of your Safety Net. Note that the roller location is different for each product.

• When two rows of anchors are installed, always use the exterior row of anchors for your Katchaleaf, even if you are replacing it without the Safety Net.

• Whenever safety is a concern, the Safety Net must be properly secured before the Katchaleaf is added. WHEN USED BY ITSELF, THE KATCHALEAF IS NOT A SAFETY PRODUCT