Paints & Finishing Products Beeck’s Mineral Paint
www.trigonos.org
Preparations
Paints and Finishing Products
Fungicide – is effective against a large number of algae, lichen, bacteria and mildew on mineral materials. Coverage depends on extent of growth but approximately 6-7 square metres per litre. PT-BF5 5kg PT-BF10 10kg
Silicate Masonry Paint (Beeckosil) - this is the paint itself. On a flat surface, the coverage is - base coat (dilute with 20% fixative) - 10 square metres per litre, top coat (dilute with 5% fixative) – 9-10 square metres per litre.
Etching Fluid – to clean and prepare all old and new mineral surfaces for use with Beeck’s Silicate Masonry Paint. It must be used with extreme care. Coverage – 50 square metres per litre. PT-BE5 5 litres PT-BE10 10 litres Silicate Filler - for levelling out mineral surfaces, e.g. for facade plasters with flaws or minor structural discrepancies or for bridging fine hair cracks. PT-BSF20 20kg Quartz Filler – a fibre-reinforced silicate primer for bridging hairline cracks and or levelling out equalising the surface. Coarse grained. Coverage – 2.5-4 square metres per litre. PT-BQF8 8kg PT-BQF20 20kg
Available in white or in the T y-Mawr ˆ colour range see page 69. PT-BSMPCODE
www.eatdrinksleep.ltd.uk
12.5 litres, 5 litres and 1 litre
BS Plus - an alkali-resistant hydrophobing agent for the clear protection of absorbent outdoor mineral surface e.g stone, brick, concrete, lime render. Water repelling (for up to 12 years externally) yet highly breathable. Provides long term protection from pollution keeping the underlying building material in good condition. It can also be used for extending the life of any of the silicate finishing products by up to 20 years. Coverage - dependant on type of stone. PT-BBSP5 5 litres PT-BBSP10 10 litres
The result : an inseparable, microporous and thus extremely vapour-permeable yet water-repelling, durable paint finish.
Fixative - a primer for absorbent mineral surfaces and thinner for the Beeckosil silicate paints. Coverage – 25 square metres per litre. PT-BFX5 5kg PT-BFX10 10kg Silane Primer – a water-repellent primer used to reduce the movement of water in the surface of a lime/cement render or limestone that may contain salts. It will help to prevent further coatings being damaged by sulphate attack. Coverage - 1.3-5 square metres per litre. PT-BSG5 5 litres PT-BSG10 10 litres Silane Primer N – as above but use this for sandstone, brick and weathered mineral renders. Coverage - 1.25-3.25 square metres per litre. PT-BSGN5 5 litres PT-BSGN10 10 litres
Restored with Beeck’s Silicate Paints. Courtesy: Bridge End Inn, Talgarth and www.theconservator.co.uk
Specialist Manufacturer and Distributor of Traditional and Ecological Building Materials and Paints
71