Upper Control Arm Removal

1. Prior to installation, verify your part number ordered with the part number received, Driver Side and Passenger Side (USA driven vehicles) stamped in the arm by the ball joint.

2. Jack up vehicle and place a jack stand under the frame rail behind the front wheel.

3. Remove wheel.

4. Open the hood of the vehicle and disconnect the negative terminal on the battery and unplug the electrical connector.

5. Unplug the electrical connector on the air intake tube. Remove the airbox by loosening the hose clamp closest to the engine.

6. Lift up on the box and remove. Then remove the wiring clips from the ECU bracket.

7. Unplug the small grey connector net to the ECU. Unplug the ECU harnesses from the ECU/ Push down on the safety latch and push the lever the opposite way. The connector will lift up, remove it completely.

8. Remove the harness clamp from the large wire loom using a small flat blade screw driver.

9.Remove the large harness from the ECU. Press lock clip and pull up on the grey lever and pull plug out.

10.Remove 3 bolts from the ECU bracket. One on the front core support, two on the fender well.