BATTEN LIGHTING
PHOENIX SENSORS Passive infra-red (PIR) and micro-wave (MW) sensors are available as pre-wired kits to be added to PHOENIX battens by the installer on site. These are a simple way to deliver big energy savings and reduced installation costs.
NHS/UHS5 PROGRAMMING HAND-SET FOR USE WITH PIR SENSORS. REQUIRED TO ADJUST THE SENSOR FOR OPTIMUM OPERATION
NHS/UHS7 USER HAND-SET FOR USE WITH PIR SENSORS. PROVIDES USER OVER-RIDE ON/OFF, BRIGHTER/DIMMER FUNCTIONS ONLY
N/PIR/EBMPIR-MB-PRM N/PIR/EBMPIR-MB-DD
3 Sensor kits are available:
N/MW/SST-MS04/ENCL
DETECTION PATTERN FOR N/MW/SST-MS04/ENCL
N/MW/SST-MS04/ENCL 2.5m
Micro-wave occupancy sensor, 5A rated. Adjustable sensitivity (range), time delay (10 seconds – 30 minutes) and lux switch-on threshold. On/off. IP20. Manual adjustment via dials on the sensor itself.
N/PIR/EBMPIR-MB-PRM
Ø 1m Minimum Ø 10m Maximum
PIR occupancy sensor, 2A rated. Adjustable sensitivity (range), time delay (10 seconds – 99 minutes) and lux switch-on threshold. On/off. IP65. Adjustment and override via infra-red handsets listed below.
DETECTION PATTERN FOR EBMPIR-MB SENSORS
N/PIR/EBMPIR-MB-DD PIR occupancy sensor, 2A switching rated and 10 pieces of DALI control gear/drivers for dimming. Adjustable sensitivity (range), time delay (10 seconds – 99 minutes) and maintained light-level functions. Broadcast DALI output for on/off and dimming control. IP65. Adjustment and override via infra-red handsets listed below. If this sensor is to be used, the fittings which it is to control must be ordered with DA in their order code, so that they are supplied with DALI control gear/drivers. A simple alternative is to install fittings that switch on at 100% when presence is detected and dim to 10% when nobody is present. This can be achieved with an on/off sensor N/MW/SST-MS04/ENCL combined with fittings ordered with CF in their order code.
140 // NVC GENERAL LIGHTING ISSUE 03
2.8m
7m
ORDER CODE
DESCRIPTION
N/MW/SST-MS04/ENCL
BATTEN MOUNT MW SENSOR ON/OFF IP20
N/PIR/EBMPIR-MB-PRM
BATTEN MOUNT PIR SENSOR ON/OFF IP65 CP
N/PIR/EBMPIR-MB-DD
BATTEN MOUNT PIR SENSOR DALI IP65 CP
NHS/UHS5
SMALL PROGRAMMING HAND-SET CP
NHS/UHS7
END-USER HAND-SET CP
+44 (0)121 457 6340 // www.nvcuk.com