Cab, specifications

The cab is elastically mounted and complies with ROPS regulations ISO 3471and SAE 1040, moreover the cab has the FOPS-approval acc. to ISO 3449 and SAE J231.

Overall body vibrations:

NOTE! On construction equipment overall body vibrations are mainly caused by various factors, such as working mode, ground conditions and the working speed chosen by the machine operator. These factors are independent from the design of the machine. It is therefore not possible to state one single value which is representative for the operator's exposure to whole body vibrations. The values for overall body vibrations stated below are in accordance with European standard EN 474-1, but are not intended to be used to determine the operator's exposure to overall body vibrations when using this machine.

According to the present technical standard the appropriate design of the operator's seat serves as the most effective means to maintain the overall body vibration of a certain machine type at the lowest possible level. The operator's seat used in this machine meets the criteria acc. to EN ISO 7096:2000, which account for the appearance of vertical vibrations under severe, but typical working conditions. This seat has been tested by applying a power density spectrum of class EM 3 and has a transmission factor of SEAT < 1.0. The overall body vibrations of the machine measured under real working conditions, as intended for the machine, are in the range from 0.5 m/s 2 up to a short term value of 1.13 m/s 2 , the seat is designed for. In order to maintain overall body vibrations as low as possible and to avoid damage to the health of the driver when working with the machine, the following rules should be observed:

Q the operator’s seat should be adjusted to the operator’s weight and height according to the specifications issued by the seat manufacturer.

Q

Q soil and ground conditions on the construction site should be kept in good condition. the machine should be used as intended. Operation and driving must be matched to the prevailing conditions, such as ground condition and particular factors influencing vibration.

Noise emission values

Sound pressure level (L pA ) determined acc. to ISO 6396 at the operator’s stand is:

L30B

Machine series 183 74 dB(A) Machine series 182, 185 76 dB(A) Machine series from: 182 6001,183 6001,185 6001 ........ See value on decal in the machine

L35B

Machine series 186, 187 78 dB(A) Machine series 188, 189 77 dB(A) Machines with the sticker "Environmentally Friendly" 74 dB(A) Machine series from: 186 6001, 187 6001, 188 6001, 189 6001..............See value on decal in the machine

The guaranteed sound pressure level (L wA ) acc. to EG-regulations 2000/14/EG around the machine is: see sticker on machine.

NOTE! No modifications must be made to the machine which could result in an increase of the noise emission.