PILOT SYSTEM/RESERVOIR AND FILTERS

Tigercat 853E Feller Buncher Safety

GENERAL SAFETY PRECAUTIONS continued

KEEP BACK 300 FEET

When approaching an operating machine on foot, stay at least 300 feet (90M) away until the operator recognizes your presence. Make sure that all harvesting equipment is shut down before advancing to the machine.

Always avoid the discharge side of a felling sawhead. A sawhead's high-velocity discharge of debris requires a safe separation distance.

Wear a suitable hearing protective device such as earmuffs or earplugs to protect against noise. Prolonged exposure to loud noise can cause impairment or loss of hearing.

Use the handrails and steps provided when mounting and dismounting from the machine. Do not climb onto or jump off the machine at any time. Do not use the seat armrest or joystick as handle when entering or leaving the cab. When mounting or dismounting the machine always use the 3 point technique - Use one hand with 2 feet or 2 hands with one foot. Avoid mounting or dismounting the machine in areas with slippery surfaces. If this is not possible clean up or cover slippery surfaces with a non-slip material. Machines should be completely cleaned of debris at least daily, particularily around the engine exhaust components. Hydraulic oil leaks, excess grease, fuel and oil accumulation (including spillage) should be eliminated immediately. Machine should be washed completely at every major service.

Keep a first aid kit in an easily accessible location on the vehicle at all times.

Do not carry passengers either in the cab or anywhere else on the machine. The vehicle is provided and approved with seating for the operator only.

Do not allow anyone to operate the machine who may not be physically fit or who may be under the influence of alcohol or drugs.

Inspect the machine daily for signs of damage, unusual wear, fluid leaks, or faulty operation. Repair or replace malfunctioning parts and systems immediately. Do not operate the machine with any defective or inoperable components. Do not operate the machine with any of the exhaust system, safety covers, or other devices removed. When moving the machine, watch that enough clearance is available on both sides and above the machine or any of its attachments. Extra clearance may be required particularly where the ground is uneven. Approach with extreme caution any area where overhanging electrical powerlines are present. Serious injury or death by electrocution can result if the machine or any of its attachments are not kept a safe distance from these lines.