Removal and Installation of Bucket

Caution ・ Stop the machine on a level location with good footing. ・ Be sure to stop the engine before beginning work. ・ When working together with others, always be sure to exchange signals and pay adequate attention to safety. ・ Always wear protective devices (protective eyewear and safety shoes, etc.) when working with a hammer.

Items to prepare •Wrench (55 mm) × 2 •Hammer •Striking rod •Screwdriver •Grease •Rag •Cleaning fluid 1.Removal of bucket [1] Place the back of the bucket parallel to the ground. [2] Use a wrench (55 mm) to remove the 2 nuts (1), and then remove the bucket side and arm side bolts (2).

[3] Use a hammer (3) and striking rod (4) to push the bucket side pin (6) and arm side pin (5) out, and then remove the bucket (7). •If a pin is hard to remove, there is a load on the pin.

Do not force it. Adjust the bucket installation position. •When removing the pins, be careful not to damage the installed O-rings or dust seals.

2.Installation of bucket

Perform the reverse of the removal procedure. •Clean each pin and pin hole. •If a pin is hard to insert, do not force it. Adjust the bucket installation position. •When inserting pins, be careful not to damage the O-rings or dust seals. •As the final step, always grease up.