CLEANING THE THROTTLE BODY

❱❘ Equipment

• Carburetor cleaner or Minerva brand universal cleaner. • Open-end wrench 8. • Socket screwdriver 7. • Hex key 2,5.

❱❘ Removing the throttle body

• Remove the seat. • Remove the fuel tank. • Remove the clamps of the throttle body. • Remove the cover of the spreader. • Remove the throttle cable. • Remove the body.

• Unplug all connectors. • Visually inspect.

• Clean with an universal cleaning solution. • Blow.

❱❘ Cleaning the throttle body

• Clean the throttle body by means of a carburetor cleaner spray (Net Carbu). • Be sure to clean the edge of the throttle valve on each side with the throttle fully opened. • Clean the injector. • Blow.

❱❘ Installing the throttle body

Reassemble the parts following the reverse order of that of the removal, put special connector grease inside the connections (power injector, GST, etc.).

If you remove the inlet sleeve, pay attention to the direction !

• Adjust the clearance of the throttle cable.

• Disconnect the computer connector. Visually inspect the connectors. • Clean with carburetor or universal cleaner. • Blow.

• Apply special connector grease. • Reconnect.