Section 3.Systems Overview Model 6210 Maintenance Manual

Operator Display and Programming

Table 3-3.Service Parameters

10PIN code (keypad only) 0 to 99991Capability to assign up to 10 PIN-key codes (for 10 different operators). A Service Key is required to assign up to 10 operators their own PIN-key code (one to four digits) for access to the truck. See “Setting Individual PIN-Key Codes” on page3-13.

NOTE: 0 disables a driver (the 2nd through 10th driver’s default PIN is 0). If all drivers are disabled, the truck cannot be driven without the service key.

NOTE: If two drivers have the same PIN number, the parameters of the driver with the highest settings are used for both drivers.

11Not used

12Throttle Map20 to 80%50%Alters the slope of the calculated throttle. 50% is a linear throttle response.

>50% provides a more rapid increase in speed at lower throttle requests.

<50% provides a slower increase in speed at lower throttle request. Maximum speed is achieved at full throttle for all response curves.

13Brake Deceleration Rate (Plugging)

1 to 53Selects from a table for deceleration rate. A higher number results in a less aggressive deceleration.

1 = hardest feel

5 = gentlest feel

14Run-Time Display 0 or 100: BSOC is the default run-time display. At power-up the Hour Meter briefly displays, then the BSOC percent is displayed during run-time

1: Hour Meter (as selected by parameter 20) is the run-time display. At power-up the BSOC percent briefly displays, then the Hour Meter is displayed during run-time.

NOTE: A setting of “1” is useful for trucks with fuel cells.

15Not used

16Travel