Electrical System

NOTE : Alternator Maintenance should be done by authorised dealer.

Too tight a belt will cause rapid wear of belt and damage to bearings.

A slack belt will not drive the Alternator, and therefore the battery will not be charged.

To avoid damage to alternator charging system, service precautions should be observed as follows,

1.Never make or break any of the charging circuit connections, including the battery when engine is running.

2.Never short any of the charging components to ground.

3.Do not use a jumper battery of higher than 12 volts.

Always disconnect the battery ground cable before carrying out arc welding on the tractor or any implement attached to the tractor. Use only specified cable for replacement

Should the starter motor be removed, and a replacement motor or drive end bracket be fitted, a check must be made of the out of mesh clearance after assembling the starter motor to the engine. The dimension between the leading edge of the pinion and the engine flywheel should be no less than 0.32 cms.