REPAIB INSTRUCTIONS, PART 2

Camshaft lnsp€ction

To arcid u¡neoe$ary derhaúti.o, co¡duct a lhoroogh iñsp€clio¡ ol lhe camshait b€for€ feinsralling áner fépracing lhe beafing báckei

Brackel Replacement Procedure

F¡gUl¿3ñfubñB¿'ngBrcchlL¡krHátr

WHEN BEPLACING FACTOBYINSIALLED JOUFNALS

. rt a camshaf jourñar has se¡zed, Do NoT túlx á r€plácaménl báaring bEckél wirh rh6 o rig lnal laclory-inslalred bearinO brack€rs. This is bsause lhe o¡iqinal bearing b€ckels were alion bored whe¡ lhé 6ñ0iné wás manutacluEd. A lsden bEckels must be

. Wheñ réptácing a cylindér héád. do nol mix ¡4 bearing b6ckelswith original b€ánng bEckers |lom lhe old cytinder head. Use onlv new beá n0 bÉckéls on a néw cvlinder

WHEN REPLACING¡NSTALLING AFTERMARXEfJOURNALS

. ll the@ are aleady repla@nént b€arlng bEcksl assmblies on the eng¡né, a¡d on€ or ñore ass€mblies áre damaged¡ all s*n 4senblies nusl be eplaced. Raplac€ménr backét assmblies can be ¡defillied by lh6 dal-shaped aliqnm6ff pin holes,

. For replacement báck6l assmblies usd ln lo€lions 2lhrough 6, both alignm6rf pin holes ar6 oval-shaped iof sideles¡de adjushenl. For bdckéls used in lo@lions 1 and 7, onealiqnméntpin hol6 is oval-shaped for l@nr-lo{ear adjushert ihe se6nd piñ hole is ound wirh an á ignmenl pln lüárk thé boaring caps lo lndi€le lhal allermaiket beáing back6t and cap ássémblies haE béén in$ánéd

L Bemow lh€ lower bea¡inq b€.kets us¡ng a pry bar The rearnosl Nó 7 b€ckál €n bé Bnded by usinq a soft-hced manet and tapping sid€ lo sidé. Crhealignmenl pins should come oll the cyl¡nder héád with lhó bEc*érs. lr ¡or, remove the pins.)

2. Clean lhe conlact sulacés of rhe oylinder hóád and lhe l@e¡ béa ng bráckets.

3. Usinq a meiatstamp or e édric éiching tool, mark thé ñ4 beanng b€ckeis and caps wilh lhe nuñb6rs, 1 th@ugh 7, ¡¡dlcaliñg the loclion ¿r whch eách ¿ssémblywilrbe

Do not e dces¡@ lc@ la pnch lhe ba.ker asñü$ whú ñatk¡ng rheit p6il¡an on the ctündet had. Dañage lo úrponenE ca, resu¡¡.

5,