Control, operation

located near the machine.

if you have not received any other instructions. controls for their proper indication.

ventilated area, if the area is enclosed. If necessary, open doors and windows in the building to provide ample fresh air. cause aslow reaction of the controls.

3.3.1.3Shutting down the machine

chock or block wheels when parking on a slope. gear brake.

well as all hoods, covers and doors; remove all keys and secure the machine against any unauthorized use.

3.3.1.4Towing the machine

operating manual.

disabled machine from a hazardous location. towing the machine, check all cables, hooks and couplers for safety and stability.

ensile strength and must be attached to the undercarriage at the designated tiedown attachment points.

permissible speed and distance. service.

3.3.2Camera system

Due to the machine design and dimensions, the field of vision from the operator's cab might be somewhat restricted. The camera system is designed to increase the field of vision of the operator and is installed in addition to the mirrors. The machine operator can thus see areas that are not directly visible from the cab. The monitor in the operator's cab shows the image captured by the selected camera.

Danger!

The camera system is only an auxiliary tool and might not capture certain obstacles. In addition, the image might be slightly distorted. It does not warn the operator if there are persons or obstacles in the danger area.

Please note: the machine operator to monitor the working area and the path of travel of the machine. ly by using the camera system! For the attachment of loads, the machine operator must always have a direct view of the load and the signaller. the aid of a signaller.

*Special equipment

Cameras A and B are attached to the platform and allow for the monitoring of the areas in front of and behind the machine. The cameras must be switched on during travel, and the monitor must be switched to the camera that captures the path of travel.

Camera C (special equipment) is attached to the bottom side of the stick. It enables the operator to monitor the area around the grapple and assists him/her in the handling of goods. The camera is intended to be used in addition to a direct view of the working attachment.

Monitoring travel path:

Switch on the camera system before putting the machine in motion.

Activate camera A or B.

Adjust the monitor image so that it matches the direction of travel and shows the route.

In the event of a failure of the camera system, the machine must be moved with the aid of a signaller.

Agree clear hand signs with the signaller or establish voice contact.