Control, operation

Operating and control elements

This menu is used to activate the application of an attachment with hydraulic cylinder (e.g. mower rake).

Menu navigation:

Use the UP and DOWN keys to select the "cylinder extern" line. Press the RIGHT key. The cursor changes to the right section where you can change the parameter value.

Use the UP and DOWN key to select the desired setting.

1 = Use of attachment possible.

0 = Use of attachment not possible. Press the ENTER button.

Move the cursor to the >back line and press the RIGHT button. The display shows the superordinate menu.

Hbg max point (optional equipment)

In situations where the machine's working space is limited in the vertical direction (e.g. by power transmission lines), it may be helpful to use stroke limitation to predefine a max. working height.

Danger!

Risk of injury and damage to equipment!

During the adjustment of the stroke limitation, there is a risk of serious damage and injury, as the equipment might collide with another object. When adjusting the limitation function, operate the machine with exceptional care.

Setting stroke limitation:

1

2 Safety margin, as prescribed m Max. working height (shut-off point)

The maximum permissible working height m must be at a sufficient distance to the object 1 that limits the vertical movement of the machine.

For the adjustment of the shut-off point, the machine must be properly supported. The settings are shown at the display in the hbg max point submenu:

*Values in cm

There are two methods to set stroke limitation:

Menu optionDescription teach point Saves the current position of the working attachment as the maximum permissible working height.

Move the stick upwards and fully tilt the digging bucket (if attached).

Move the attachment to the desired maximum working height.

Move the cursor to the teach point line and press the RIGHT key to change to the right field.

Press the UP button to enter the value "1" and confirm with ENTER

The current working height (act. max. point) is saves as the maximum permissible working height (hbg max point).

Move the cursor to the >back line and press the RIGHT button.

The display shows the subordinate menu.