SPACER

1. Fasten a chain or cable around the middle of the fender. Make sure the chain or cable is in the slot on the side of the fender.

2. Raise the fender to the lift truck. Align the dowels of the fender with the hole in the frame.

3. Install the bolts, washers and nuts that hold the fender to the frame. Tighten the nuts to 814 N.m (600 lbf ft).

HOOD AND BALLAST COVER

The hood and ballast cover can be removed from the frame. To remove the hood, remove the four nuts that hold each hinge bracket to the frame. Lift the hood from the frame. Align the hood as necessary during installation.

To remove the ballast cover, remove the four capscrews that hold it to the frame. Lift the cover away from the frame.

HYDRAULIC TANK (See FIGURE 1.)

The hydraulic tank on the H16.00–32.00C (H360–650C, H370–700C) lift trucks is installed on the left–hand side running board. The hydraulic tank on the H36.00–44.00B (H700–920B) lift trucks is installed between the legs of the tilt cylinder mounts.

Removal, H16.00–32.00C (H360–650C, H370–700C)

1. Pull the handles and close the two shut–off valves at the hydraulic tank. Put plugs in the open holes. If necessary remove the drain plug at the bottom of the tank to drain the oil.

2. Disconnect the lines for the pumps and the return lines. Put caps on the open lines. Put tags on the lines for identification.

3. Remove the capscrews that hold the top of the tank to the frame. Lift the tank from the frame.

FIGURE 1. HYDRAULIC TANKS

H16.00–32.00C (H360–650C, H370–700C)

H36.00–44.00B (H700–920B)

1.BREATHER 2.TANK 3.ELEMENT 4.SPRING 5.VALVE 6.GASKET 7.VALVE BODY 8.SPRING 9.HANDLE 10.DIPSTICK 11.HANDLE 12.O–RING 13.PLUG 14.VALVE 15.INDICATOR 16.HEAD 17.SNAP RING 18.BAFFLE

8670