IV. PREPARING TO OPERATE

Attaching Ls System And Depth Command

1. Install Tasseltrol®/LS sensor mount support weldment with the two nylon washers (fig. 4.23, item 2) in the forward– most hole of the tool bar (fig. 4.23, item 1).

2. Install the Tasseltrol®/LS sensor mount (fig. 4.23, item 3) to the sensor mount support weldment (fig. 4.23, item 2).

3. Install the cable assembly according to the wire diagram in the Hagie 204SP Parts Manual.

4. Turn the ignition key switch to the “ON” position to check the sensor installation. DO NOT start the engine. See page 59 for more information about the LS sensor assembly.

5. Attach the depth command actuator (fig. 4.24) to the light sensor mount and the tool bar. See page 60.

NOTE:

Over tightening of the sensor arm pivot mounting bolt (fig. 4.23, item 1) may cause the actuator to stall.