Swing-away lattice 3.3 Checklists for rigging work

18. Install the anemometer and if necessary establish an electrical connection for the air traffic control light; à Installing/removing the anemometer, p.3-83, à Air traffic control light – electrical connection, p.3-85.

19. Install the lifting limit switch; à Installing/removing the lifting limit switch, p.3-80.

20. In the case of the inclinable swing-away lattice, adjust the angle, if necessary; à Setting the angle – with the auxiliary crane, p.3-91. à Setting the angle – without the auxiliary crane, p.3-92.

21. Reeve the hoist rope on the hook block; à Possible reeving methods on the swing-away lattice, p.3-79.

22. Attach the lifting limit switch weight and place it around the hoist rope; à Operating instructions GMK5170, section 2 Superstructure – Rigging work.

23. Check the horizontal alignment of the truck crane and correct, if necessary.

24. Enter the current rigging mode with the rigged swing-away lattice; à Setting the SLI, p.3-99.

25. Enter current reeving; à Setting the SLI, p.3-99.

Further steps with swing-away lattice: –Raise main boom; à p.3-101. –Telescope main boom; à p.3-102.