ASSEMBL Y

2 - GENERAL INFORMA TION ###_1_###

Basic instructions

PLEASE READ THE COMPLETE INSTRUCTIONS BEFORE ARTING ASSEMBL

References the right - hand side and the left - hand side are determined standing the rear the machine and facing the direction travel.

NOTE: Using the Hardware T orque Chart, found in the service manual, torque all the hardware the specified torque unless otherwise specified within the instructions.

NOTE: Using the Hydraulic Fitting T orque Chart, found in the service manual, torque all the fittings the specified torque unless otherwise specified within the instructions.

NOTICE: not tighten the hardware until instructed in the assembly instructions.

NOTICE: Be sure use the hardware specified when using tapped holes, trying install a metric bolt in inch thread inch bolt in a metric thread will damage the threads.

NOTE: Install flat washers over all the slotted holes unless truss - head carriage bolts are used. Install a lock washer all bolts, unless a jam nut self - locking nut is specified.

NOTE: Install special hardened washers where specified.