Hydraulic Tank..............................................................................................................................7

Suggestions

Reassembling Differential Pinions

The thrust washers of the differential gears are to be used for adjusting the backlash between the differential gears and pinions.Measure the backlash and, if it exceeds the limit, replace the thrust washers.

Backlash between differential gears A 0.18 to 0.23 (0.0071 to 0.0091) and pinions B 0.5 (0.020) Unit:mm (in.)

A = Assembly Standard B = Repair or service limit

Reassembling Differential Case

After putting the case assembly in place on the carrier, install the bearing caps tentatively by making the cap bolts snug tight.The caps are to be secured tight after the bearing preload has been adjusted.

Installing Bearing Caps

Be sure to know which are the left and right caps and to put each cap in place correctly.

200244

Installing Reduction Gear

Apply LOCTITE No.271 to the bolts for holding the reduction gear to the case.Be sure to tighten these bolts evenly so as not to strain the gear.

Tightening torque for reduction gear bolts 12.0 kgf•m (87 lbf•ft) [118 N•m] Tightening torque for bearing cap bolts 12.8 kgf•m (93 lbf•ft) [126 N•m]

200241