Product identification

Fuel

Use only Low Sulfur Diesel that meets the National Regulations for commercial diesel fuel. NOTICE: Never use Diesel fuel having a sulfur content higher than 350 ppm .

Using other types fuel may lead stalled engine output deterioration in fuel economy . NOTICE: The warranty shall invalid if any serious defect is caused usage any other fuel. Using any fuel other than the prescribed type will cause damages the fuel supply system, the fuel injection system, and the engine block. CASE CONSTRUCTION will not responsible any such damages.

the temperature drops below the fuel cloud point, output deficiency engine start problems may occur due wax crystals. NOTICE: operating in severe winter climate, consult the fuel supplier the CASE CONSTRUCTION dealer for specific diesel fuel used.

The diesel fuel used the machine should: • free from dust particles, even minute ones. • have the proper viscosity . • have a high cetane number . • present great fluidity low temperatures. • have low sulfur content. • have very little residual carbon. NOTICE: Never use a mix diesel fuel and old engine oil. The fuel injection system and the exhaust after treatment system will severely damaged. NOTICE: consult the fuel supplier the CASE CONSTRUCTION Dealer regarding appropriate use fuel additives. NOTICE: in order prevent condensation during cold weather , fill the fuel tank full after completing the day's work.

Fuel storage:

Long storage can lead the accumulation impurities and condensation in the fuel. Engine trouble can often traced the presence water in the fuel. The storage tank must placed outside and the temperature the fuel should kept low possible. Drain f water and impurities regularly .

Disposal fluids, lubricants, and spare parts

Fluids, lubricants and spare parts used the machine are not fully compatible with the environment. Make sure carry out all maintenance operations using appropriate tools, in order avoid any risk damaging the environment. NOTE: for example, make sure that the receptacle for collecting oil replaced is not leaking.

Never spread fluids lubricants the ground into water . Consult the CASE CONSTRUCTION Dealer the Local Environmental Agency in order obtain information the correct method disposing fluids and lubricants used the machine.

Never throw away spare parts filters batteries. Consult the CASE CONSTRUCTION Dealer the Local Environmental Agency in order obtain information the correct method disposing filters, batteries other spare parts used the machine.

Fluids and lubricants

CX220C Crawler excavator LC version ier 3) - Commonwealth of Independent States (CIS) CX220C Crawler excavator NLC version ier 3) - Commonwealth of Independent States (CIS)

By using appropriate fluids and lubricants the excavator can operate in ambient temperatures ranging from -

°C

(-4 °F ) °C ( °F ). Refer the list fluids and lubricants contained in this manual. NOTICE: When operating the machine in ambient temperatures below °C (-4 °F ), consult your CASE CONSTRUCTION Dealer for specific machine provision and for specific fluids and lubricants used. NOTICE: When operating the machine in ambient temperatures above °C ( °F ), the engine oil must replaced with SAE 15W .

Quantity CASE CONSTRUCTION specification Reference specification

Fuel tank

410 L

( 108 gal ) GOST R52368 T ype I

Engine oil 23.1 gal ) L ( 6.1 CASE AKCELA NO. ENGINE OIL 1 121 SAE API 10W -4 -

Swing reduction unit 5 L ( 1.3 gal ) CASE 80W AKCELA GEAR LUBE 135 H EP 1316 SAE API 80W -5 /

T ravel reduction unit 5 L ( 1.3 gal ) CASE 80W AKCELA GEAR LUBE 135 H EP 1316 SAE API 80W -5 /

Engine coolant L ( 8.2 gal )

CASE AKCELA ACTIFULL™

EXTENDED LIFE COOLANT

CONCENTRA (*)

CASE AKCELA ACTIFULL™ EXTENDED LIFE COOLANT

/ PREMIXED

T3624

Grade T- EG1

T3624

Grade T- EG2

ASTM D6210

TYPE I-

ASTM D6210 TYPE III -

Hydraulic oil tank (**) ( 147 38.8 L gal ) CASE AKCELA HYDRAULIC —

ISO 11 158

L- HV46

Grease —

CASE AKCELA 251H EP MUL PURPOSE GREASE

B251H EP NLGI 2

(*) Concentrate antifreeze mixed / with distilled (deionized) water .

(**) The total capacity the hydraulic system is: 240 L ( 63.4 gal )