Application of auxiliary tractor equipment

It is strictly prohibited to use rear lift linkage, when towing device is installed on tractor!

Trailers are operated at speeds, defined by the road conditions. It is allowed to operate with trailers 2PTS-4-887А, having body capacity of 20 and 45 cubic meters, at speeds up to 15 km/h, as they have lesser stability. To prevent damage to rear wheel fenders, avoid sharp turnings of these trailers and thrower 1RMG-4. Hinge of trailers (2PTS-4-785А, etc.) should be secured from turning to avoid its cramping. During the operation the fork of TSU-1Zh should be fastened on the crossbar of drawbar hitch with two pins. It is prohibited to operate with the fork, fastened with one pin. Before operation make sure that pins and pivot bolts of drawbar hitch fork are securely fastened by cotters. Switch on all the trailer signal devices (stop-signals, turn signals, number plate light) through coupling socket, installed on the tractor.

Application of tractor auxiliary equipment

Following auxiliary equipment can be installed on the tractor: power pulley, additional ballast weights for additional loading of front axle, reducing gear, automatic hitch SA-1, spacer for doubled rear wheels installation and other equipment. Power pulley is installed on reducer cover of rear PTO and is rotated by splined PTO drive end. To avoid PTO drive end deformation, be sure to provide body installation on four cotter pins with flange alignment in the PTO cover. Pulley engagement and disengagement is performed by PTO control lever. Additional ballast weights with total mass of 220 or 510 kg are installed on special bracket, which fastened to tractor front beam. Reducing gear is installed to make it possible to apply the tractor with machines, requiring underspeeds. By the means of reducing gear tractor speeds are geared down additionally in I and II gears, forward and reverse (reducing gear is optional).

To install reducing gear on tractor, implement recommendations, stated in “Technical manual for reducing gear service instruction”, attached to every reducing gear being dispatched under customer order.

IMPORTANT! After reducing gear installation on tractor, fill the power train with oil up to the level of check plug and add 10 liters more.