Top View

The diagnostic problems does not identify which devices fail, which devices are incorrectly installed, whether a short circuit happens, or whether the system is inoperative. NOTE: Verify if all devices attached are supported by the computer. NOTE: Verify if the power supply used at the time of failure is operating correctly. You can refer to “Power System Check”. Follow the procedures below to isolate the failing FRU. Do not isolate non-defective FRU. 1. Power off the computer. 2. Visually check the devices. If any problems are found, replace the FRU. 3. Remove or disconnect all of the following devices: Non-Acer devices Printer, mouse, and other external devices Battery Pack Hard disk drive DIMM CD-ROM / Diskette drive module PC cards 4. Power on the computer. 5. Determine if the problem has been resolved. 6. If the problem does not recur, reconnect the removed devices one at a time until you find the failed FRU. 7. If the problem remains, replace the following FRU one at a time. Do not replace a non-defective

FRU. System board LCD assembly

Jumper and Connector Location

Top View

No. Description No. Description

1 DC-in jack 2 USB connector 3 CRT connector 4 RJ11 & RJ45 connector 5 MDC module cable connector 6 MDC board connector 7 Main battery connector 8 ODD connector 9 Mini PCI slot 10 North bridge 11 CPU 12 DIMM slot