PWnov19pgs_cs.qxp_Layout 1 10/4/19 9:59 AM Page 42
AIR
EMISSIONS
LDX SOLUTIONS
LDX Solutions was formed in 2019 as the next evolutionary step resulting from the 2016 merger of Dustex LLC and Lundberg LLC. As the home for the Geoenergy E-Tube Wet ESP, GeoTherm RTO, and GeoCat RCO technologies, LDX Solutions is a mainstay supplier in the panelboard industry. Since 1984 more than 150 Geoenergy E-Tube wet ESPs, treating over 10,000,000 cfm of waste gases have been successfully applied in the panelboard industry. These installations have included all common forms of wood dryers to include gas/steam/wood heated veneer dryers, rotary drum dryers for particleboard and OSB production, and flash tube dryers for MDF manufacturing, as well as presses The E-Tube wet ESP design exploits the intense electric field of the disk-intube configuration to yield the best particulate removal performance possible. Both theoretical analysis and empirical data show that there is no higher-perform- Geoenergy has installed regenerative oxidizers ing wet ESP design available. since 1995. The Geoenergy GeoTherm and GeoCat regenerative oxidizers have also received wide acceptance in the panelboard industry. Since 1995, over 50 of these units have been installed on wood dryers and presses treating more than 3,000,000 cfm of VOC-contaminated emissions. Both of these regenerative oxidizer products have consistently achieved over 98% VOC destruction and, at times, have been tested at greater than 99% efficiency. This excellent performance is always achieved at minimum fuel consumption. In fact, at several GeoCat installations the catalytic operation allows the oxidizer to run with virtually zero auxiliary fuel. The second generation of GeoTherm and GeoCat designs offer the same excellent VOC destruction efficiency and low energy consumption as the original design with substantially reduced cost. Both wet ESP and regenerative oxidizer products are supported by the LDX Solutions experienced engineering and field service professionals. This support team will tackle any project ranging from simple equipment-only supply to the most complex turnkey installation project. After a project is started up and operating, customers can continue to rely on our large and experienced field service staff.
42 • NOVEMBER 2019 • PanelWorld
CLICK HERE IF YOU HAVE NOT ALREADY OPTED IN!