COMMERCIAL FEEDERS
SQUEEZE AND FEED METHOD MOULD The Squeeze and Feed Method moulds are available in three sizes and are designed to work with all of the Evolution Method Feeders (both In-Line and Elasticated). We have designed the moulds to be deeper than other versions on the market, which allows you to use more bait on the feeder should you want. This extra depth also provides more movement for solid compression when loading a feeder. The mould couldn’t be easier to use and works perfectly with both groundbait and softened pellets. Simply place your hookbait into the mould and then fill it with the groundbait or damp pellets of your choice. Push the feeder face down into the mould, turn the mould over and squeeze both sides. The Method feeder will release from the mould perfectly loaded, with the hookbait on top and ready for casting.
The small holes in the base of the mould prevent a vacuum forming during compression producing a better loading
The deep moulded ends accommodate most Method feeders and provide more movement for compression The unique design of the base, with central slots and compression sides, enables the feeder to be ‘squeezed’ out
METHOD FEEDER MOULD • For use with all Matrix Method feeders • Also works with many other flat Method feeders • Deep design lets you load up the Method feeder with more bait than normal moulds if you want • Soft malleable material for easy release of feeder • Available in 3 sizes • SMALL GFR123 £3.25 • MEDIUM GFR050 £3.49 • LARGE GFR061 £3.99
1
Start by placing your hook through the hole in the base of the feeder.
2
Next place the Rubber Quick Bead through the same hole in the base.
3
Carefully position your mainline through the slot in the back of the stem.
4
Push your tail rubber back down over the stem to secure everything in place.
56 Matrix Cat 2018_54-67.indd 56
24/11/2017 19:04:09