input level Adjustment Before starting to use the 9001, you should adjust the input sensitivity to match the level of the sound source. This will ensure optimum sound quality with a minimum of noise. When the 9001 has been properly connected to the sound source and the playback equipment, turn on the power in the following order: -+ Sound source + 9001 -+ playback equipment I f the above sequence is not observed, turn-on thumps may damage the speakers. To turn the equipment off, reverse the above sequence.
The Play mode display appears. STUDIO DRUMS KEYB. PIANO
mumlc
TAR BASS VOCAL SOUND
l
The display shown above is only an example. In actual use, the display will be different depending on the status of the 9 0 1 before it was last turned off. I n other modes, an "E" o r "U" is shown in the left section of the display. If this indication is not shown, the unit is in the Play mode.
Press the UTILITY (TYPE) key.
This activates the Utility mode. A "U" appears in the left section of the display. ACWSTlC SNOlO DRUMS KEYB. PIANO GUITAR BASS VOCAL SOUND
Use the VALUE +/- keys to adjust the input sensitivity of the 9001.
Set the output level of the sound source to the normal value. Then adjust the input sensitivity of the 9001 with the VALUE +/- keys so that the SIGNAL indicator lights up in yellow during input signal peaks. The input sensitivity can be set in five steps, from 1 to 5. When the adjustment is completed, press the UTILITY key several times until the unit reverts to the initial display (no "U" shown).
The 9001 is now again in Play mode.