Advanced Programming Set the On Light Level of an RTA-WX-2B There are two methods to adjust the light level: Remote, using the RTA-WX-2B; or using DIP switch 1 on the RadioTouch controller. Note: The controller will not react to preset button presses from a transmitter while the controller’s DIP switch 1 is in the down position, or while the controller is in preset adjust mode. Preset light levels may be affected by daylight sensor input. As ambient light increases or decreases the preset light levels will scale accordingly.
Remote Method Note: No DIP switches need to be switched to perform this operation.
DIP Switch Method Step A: Flip DIP switch 1 down on the controller. After the switch is flipped the controller will be in preset adjust mode. (If a photosensor is connected to this controller your lights may change level when DIP switch 1 is flipped.) Step B: Using the raise/lower buttons on the RTA-WX-2B transmitter controlling the controller that you are adjusting, set the lights at the new On level. Step C: Press and hold the On and raise buttons for 5 seconds. The lights will flash to notify you that the On level has changed. Step D: Flip DIP switch 1 back up to exit preset adjust mode.
Step A: Press and hold the On and the lower buttons for 5 seconds. The lights will flash to notify you that you are in preset adjust mode, and settle at 100% light level. Step B: Using the raise/lower buttons on the RTA-WX-2B transmitter controlling the controller that you are adjusting, set the lights at the new On level. Step C: Press and hold the On and raise buttons for 5 seconds. The lights will flash to notify you that the On level has changed. Step D: Press and hold the On and the lower buttons for 5 seconds to exit preset adjust mode. The lights will flash and return to their maximum light level. Test the On button to make sure the light level is correct. If not, repeat steps A through D.
DIP Switch Method
Remote Method RadioTouch RTA-RX-F
120/277 V 16 A Max.
TM
LISTED 243C Ind. Cont. E q.
Coopersburg, PA 18036 USA
CONFIGURACIONES REGLAGES SETTINGS PWR
STAT
ON
5
6 7
8
+
5
_
4
PS S ig
Occ. S ig
3
24 V
4
1 2
15 V
3
Occ. Com
OFF
Cir Com
2
PELV (Class 2: USA)
1
OFF
0-10 V
®
®
Refer to the Installers Guide for more detailed instructions. Consulte la Guía de Instaladores para información más detallada. Référer au Guide d’installation pour plus de renseignements détaillés.
1-800-523-9466 1-888-235-2910
USA, Canada Mexico www.lutron.com
ON
PROG
ON
100 Hr/100% P/N 500-10633 © 2006 Lutron Electronics Co., Inc.
ON
60 Hz
OFF
ON
1
2
3
4
5
1
Press and hold for 5 seconds to enter preset adjust mode
Press and hold for 5 seconds to set the new On level
R
2
3
4
5
6
7
8
Set DIP switch 1 to down position to enter preset adjust mode
Press and hold for 5 seconds to set the new On level
RadioTouchTM Installation Guide
37