Command Set: RTA-RS232 Commands Command Name Description Syntax Allowed Values Example Additional Information
PS (preset) Sets the indicated zone to a predetermined preset level :PS,[zone number],[preset number]<CR> Zone number: 0 through 9 Preset number: 0 through 16 :PS,6,5<CR> Sets the level for zone 6 to preset level 5 Preset Light Levels: 16 are available with the RS232 interface. Presets 1through 5 correspond to buttons on a RadioTouch wall control (see below) and will take the RF controller to the same light level as a button press on the wall control. Presets 6 through 8 can be accessed only via the RS232 interface or the RTA-SCI. Presets 9 through16 can be accessed only via the RS232 interface.
Preset Preset Preset Preset
1 2 3 4
Preset 5
ON
OFF
RTA-WX-5B
RTA-WX-2B or RTA-WX-2BSW
Preset Contact Closures: 5 are available on a RTA-RX-F-SC controller and can be accessed with the RS232 interface using presets 1 through 5. Contact closure outputs are primarily used to control Sivoia QED controllable window treatments, AC motorized shades, and projection screens.
Closure/Preset 2 Closure/Preset 4 Closure/Preset 3
Lights n
Shades
Projectio
Closure/Preset 1 Closure/Preset 5
RTA-WX-F-SC
OPEN
STOP
CLOSE
AC Shades RTA-WX-C3LB
Preset 2 Preset 4 Preset 3
UP
DOWN
Preset 2 Preset 4
OPEN
PRESET
CLOSE
Projection Screens RTA-WX-C2LB
Preset 2 Preset 4 Preset 3
Sivoia QED Shades RTA-WX-Q3LB Note: Press any button (or activate any preset) when Sivoia QED shades are moving to stop them where they are.
14
RadioTouchTM RTA-RS232 Programming and Operation Guide
R