Operation
Premier Control System
(Bullfrog Spa models only)
General The pump responsible for heating and filtration is pump 1 or optional circ pump. Timeouts refer to a preset length of time that a function is programmed to operate before shutting off automatically. Certain conditions (filter or freeze) can cause a function to operate longer, while faults can cause a function to operate for a shorter length of time. The system keeps track of timeouts regardless of other conditions. NOTE: In multibutton sequences (shown by the + sign), if subsequent buttons are pressed too quickly the desired result may not occur.
TM
F1 F2
Icon Legend Heat Icon - Indicates different stages of heating. Jets Icon - Spins fast on high speed/spins slow on low speed Light Icon Setting the Time Once the spa has been properly connected the TIME icon will appear on the control panel’s liquid crystal display (LCD). Press time + mode/prog. Select the hour by pressing warmer or cooler. (Each press changes the time by 1 hour.) Press mode/prog to switch to minutes. Select minutes by pressing warmer or cooler. (Each press changes the time by 1 minute.) Press time to confirm. Press mode/prog to exit the time setting procedure and enter the optional filter cycle programming. Press mode/prog to exit programming. NOTE: Time settings are not preserved in the event of a power loss. Filter Cycles NOTE: At the start of each filter cycle, the lowest speed of jet pumps will run for 5 minutes to clean out the JetPaks™ and JetPods ™. NOTE: Allowing the filter pump to operate for extended periods of time with the cover on the spa will result
26
warmer
light
option
mode/prog
cooler
jets 1
aux
TL
Premier Control System One Pump
TM
F1 F2
Initial Startup Before turning on the power to the spa, make sure the spa is properly filled with water and the equipment door has been secured. When your spa is first actuated, it will begin the Priming mode. The Priming mode will last for up to 4 minutes, and then the control system will begin to heat the spa and maintain the water temperature in the Standard mode. Press warmer or cooler to exit the Priming mode early.
time
PL
time
warmer
light
option
mode/prog
cooler
jets 1
jets 2
PL TL
Premier Control System Two Pumps
in a rise of the spa water temperature. During warmer months of the year, it is advisable to set the duration of the filtration cycle to the minimum level needed to keep the water clean. NOTE: The pump and ozone purifier* will run during filtration. Preset Filter Cycles: Your spa came programmed from the factory with these defaults. There are two filter cycles per day. The first filter cycle will automatically activate at 8:00 a.m. and will operate for 2 hours. The second filter cycle will automatically activate at 8:00 p.m. and will operate for 2 hours. The start and end times of the filter cycles are programmable. To program, set time as instructed in Setting the Time and follow the instructions in Custom Filter Cycles. Custom Filter Cycles: To program custom filter cycle settings, press time + mode/prog + mode/prog + mode/prog within 3 seconds. The PROGRAM, FILTER 1, and START TIME icons will appear on the display. Press warmer or cooler to choose the filter start time hour. Press mode/prog to enter the hour. Press warmer or cooler to choose the filter start time minutes. Each press changes the start time by 5 minutes. Press mode/prog to enter the minutes. Press mode/prog to see the PROGRAM, FILTER 1, and END TIME icons. Adjust the time as done above. Press mode/prog to see the PROGRAM, FILTER 2, and START TIME icons. Proceed as above. Press mode/prog to see PROGRAM, FILTER 2, and END TIME icons. Adjust the time as previously stated. Press mode/prog to enter the new filter cycle times into the system and display the current water temperature. Press time at any time during this programming sequence to save the values entered up to that point and exit programming.