TPMS
Figure 4: Removing and Installing Tire Pressure Transmitter. Lubricate the tire well, and remove the top side of the tire. Reach inside the tire and remove the transmitter.
Figure 3: Positioning Tire On Turntable. Carefully lift the tire onto the turntable and position the valve hole and transmitter 270 degrees from the mounting/demounting head.
provided “asleep” and must first be “woken up” using Transmitter Activation Tool J-45295 or Signal Tech II Tool J-50190 before ID registration can be performed. Use the following procedure when using the Transmitter Activation Tool J-45295: 1.
With the ignition switch in the OFF
IS THE ONLY
COMPLETE
2. 3.
position, connect the scan tool to the DLC. Turn the ignition switch to the ON position; Display the “WORK SUPPORT” screen and select “ID REGIST;” With the Transmitter Activation Tool (J-45295) pushed against the left front tire air-valve, press the button for
TPMS MANUFACTURER TO OFFER A
SOLUTION
OE QUALITY SENSORS
POWERFUL SCAN TOOLS
UPDATES POWERED BY
DIAGNOSTICS
ALUMINUM OR RUBBER VALVE STEMS AVAILABLE
1-SENSOR • 1-SKU Limited Inventory • Dual Frequency 315MHz + 433MHz • 99% Vehicle Coverage • Interchangeable Valve Stems
TS508KMV-1 • Read/Relearn All Known Sensors • 4 MX-Sensor Programming Methods • FREE Software Updates for Life of Tool • Exclusive TPMS Status Screen
CONTACT YOUR AUTEL DISTRIBUTOR FOR MORE TPMS KIT OPTIONS SCAN TO WATCH
TEL: 1.855.288.3587 I WEB: AUTEL.COM EMAIL: USSUPPORT@AUTEL.COM AUTEL.COM FOLLOW US @AUTELTOOLS ©2021 Autel U.S. Inc., All Rights Reserved
TRAINING VIDEOS
YOUTUBE
4. 5.
DEMOUNTING/MOUNTING PROCEDURES
CAUTION: The tire should be demounted from the wheel using the tire changer manufacturer’s instructions. Use the following information to avoid damage during the demounting/mounting procedures. Also ensure there is no metalized film or any metal parts (antenna, etc.) on the windows, as this may cause poor reception of the signals from tire pressure sensors and the TPMS will not function properly. NOTE: When a spare tire is mounted or a wheel or tire pressure sensor or low tire pressure warning control unit is replaced, the tire pressure sensor must be registered. See RESET PROCEDURES. TIRE PRESSURE SENSOR CAUTION: Do not inject any tire liquid or aerosol tire sealant into tires, as this may cause a malfunction of the tire pressure sensors.
94 1SensorKits-TS508-4.563x4.875-TPS-MTD-06172021.indd 1
06_MTD_Columns-TPMS.indd 94
five seconds. (See Figure 1.) Sensor activation must be performed in the order listed: left front, right front, right rear and left rear. As each sensor ID is activated, the TPMS warning light flashes is the pattern shown in Figure 2 and the scan tool indicator light changes from red to green; Check that the turn signal lights blink twice when the transmitter wake-up procedure for all wheels is completed; After completing the wake up of all transmitters, make sure the TPMS warning light goes out.
MTD September 2021 6/17/21 7:15 PM
9/2/21 2:10 PM
