Electrical system
The engine pick-up is situated on the left side of the motorcycle. To check this component it is necessary to identify the relative connector positioned as shown in the figure, inside the frame on the left side of the motorcycle. ENGINE PICK-UP
E After having disconnected the pick-up connector, measure the resistance between the two points identified by a (+) and a (-) that are indicated on the connector. Pick-up resistance value: ~ 680 – 700 ΩΩ
E.A.S. (electronically assisted shift is not included in all models) E.A.S. mode, which can be selected from the menu, is used to change gear without using the clutch and without closing the gas knob. Installed on the gear change rod, this device detects the pressure exerted on the gear lever and sends the information to the ECU, which blocks the supply of electric current to the reels by lowering the torque value of the gear for the amount of time required to engage the next gear. Remove the connector and check continuity between pins 2 and 3 through the pressure sensor (gear lever raised).
- 25 -