Top Tips on New Water Heater Installation in Manhattan As years pass every home needs a new water heater. This all totally depends on the weather conditions of the region you live in, how well it was installed and how often you have regular maintenance on it.
Replacing a water heater is a complex process that most people can't handle without the help of an expert plumber. On a Sunday morning isn’t it quite annoying to notice that your old water heater stopped working and you don’t have hot water? You may be getting worried about what to do next? Where to find a plumber on a Sunday? Well, this article is a complete guide which helps you with the tips on how to install a new water heater in Manhattan.
Step 1: Selection of New Water Heater Make sure you replace your old water heater with the new one which has the same fuel type either oil, gas or electric. If you want to upgrade your water heater capacity make sure the one you buy one that has enough space to install it in to fit the larger capacity water heater. Step 2: The Preparation for Installation The following guideline list will help you when replacing your old water heater with new one. Check plumbing Quick tip for plumbing is to measure the space and location before installation of new one. On the top of water heater measure the dimensions between the hot and cold water pipes are the same as new heater. If it is a gas heater make sure the gas line accessible. Also, make sure there is a closet for the cold-water inlet pipe and a connector for the hot water outlet pipe. Setup It is likely that you will need the assistance of a helper or professional plumber to ensure the settings for the new heater are done properly. Step 3: Turn off the water heater utilities Make sure the connection of water utilities to the water heater be it in electric mode or gas is turned off. In case of electric water heater, you need to shut off the electricity supply by turning off the water heater circuit breaker or its fuse. Whereas if your water heater tank runs on gas, turn off the gas on the gas supply line and disconnect the gas line. Step 4: Drain the hot water Make sure to drain the water from tank once water is turned off. Attach a hose to drain valve on the water heater then open the hot water faucet. To drain the water place another end of the hose or pipe on the floor and then open the valve. Make sure to have extra towels or buckets around just in case. Step 5: Disconnect utility lines, remove and replace Whether it’s the electric or gas heater, next step is to disconnect the utility lines. Once all lines from the heater are disconnected, you are all set to remove the old heater and replace it with the new one. Step 6: Connect electric or gas pipes and install the fittings With the help of a helper or professional plumber, install the fittings. This is usually done with copper flex lines by making connections to the old water heater’s location. Then connect the electric or gas pipes to the new heater
Step 7: Attach lines and set temperature In case you are fixing a gas water heater then make sure to attach the lines by attaching the draft diverter over the water heater line. Fill the heater tank with cold water, once it is done switch on the main gas, then the heater to heat the water. After going through these easy tips on Water Heater Installation, ensure that your bathroom and kitchen are inspected for these chilly winter months. If you still need assistance or need professional help, don’t hesitate to contact C James Plumbing, with over 20 years of plumbing and heating in Manhattan.
Original Source: https://medium.com/@cjplumbing23/top-tips-on-new-waterheater-installation-in-manhattan-dd4959f748af/