6
News
TOP 3 DIY LIGHTS Create a stylish statement with these easy-to-install pendants
Brilliant ‘Havana’ DIY plug in pendant in Deep Natural Rattan, $44, I/N: 0089051
Why it’s great
Antique brass and a matt black finish combine to bring a retro look to your lighting scheme
Mercator ‘Ruben’ 27cm batten fix light in Black, $52.50, I/N: 4371403 (bulb not included)
LIGHT RELIEF
Upgrade a daggy light fitting in minutes – without a sparkie – with a DIY pendant light
EXPERT TIP
A DIY pendant works by replacing the old light bulb with an adaptor that plugs into the existing bayonet batten fixing. Turn off the power before installing, wear gloves and safety glasses in case of broken glass, and dispose of the old bulb responsibly. We used Brilliant ‘Milly’ DIY suspension light in Gloss White, $24.95, I/N: 0089045, which uses an Edison bulb (not included), and these instructions relate to that product; use them as a guide, and refer to the specific instructions in your chosen kit.
An ‘Edison’ bulb has a screw-in base, while a bayonet bulb has pins so it twists to lock. Always check which bulb is required
TOOLS & MATERIALS
Safety equipment Stepladder Screwdriver Ceiling paint 50mm angled paintbrush DIY plug in pendant kit Light bulb
2 Gently twist the old light bulb to the left to remove it, leaving the batten holder attached to the ceiling. Tip: If needed, touch up the ceiling paint using a 50mm angled brush.
Brilliant ‘Elliot’ concrete DIY plug in pendant in Cream, $44, I/N: 0089052 (bulb not included)
3 Unscrew the DIY pendant’s cord anchor and slide the cover 200mm down the cord. Why it’s great
Go for maxiumum impact and install a black wire shade in a striking geometric design
Brilliant ‘Trinity’ metal wire batten fix light in Black, $53, I/N: 4371035 (bulb not included) Some products are not available at all Bunnings stores, but may be ordered. 4 To fit the plug, line the pins up with the slots in the batten holder, push up gently and twist to the right. Tug gently to check it is secure. bunnings.com.au |
bunnings |
5 Slide the cover up and over the batten holder to position against the ceiling, then tighten the cord anchor to hold it in place. bunnings
6 Install an Edison bulb inside attached shade by twisting it to the right. Turn the power back on and switch on the light.
DISPOSING OF OLD BULBS Not all light bulbs are created equal and should be disposed of accordingly. The guides vary by state, so it’s best to check your local council’s recommendation. Never put bulbs in your home recycling bin. ◆
Photography Larnie Nicolson, styling Sam van Kan. Instructions and steps photography Natasha Dickins
1 Turn power off. Set up a stepladder on a stable surface. Remove old light shade. Use a screwdriver to check the screws in the batten holder are tight and it can support the new light.
Why it’s great
Industrial chic meets coastal elegance with this stone-look concrete and resin pendant