Tube Benders Bendarc Tube Bender
Adjustable Eye Ends
▲ Bendarc Quick-Switch - Gives strong bends with smooth, rounded corners. ▲ Designed for wall or bench mounting and easy pull down use, Bendarc can bend 152mm/6 inch radius to 300mm/12 inch radius, depending on which dies are purchased. ▲ Easy, pull-down use. Wall mounting allows your body weight to help. ▲ Quick and easy to switch sizes. ▲ Constructed of boiler plate steel with bearing supported roller and powerful 998kg/2200 lb. clamp. ▲ Rollers are high density polymer for mar resistant contact with fine tubing finishes. ▲ Other size radius dies, rollers are available.
▲ Designed to tighten canvas on bimini tops. ▲ A pair can adjust 2 inches in length. ▲ One pair = one right and one left thread. ▲ Requires one pair per strut - 2 pairs to make a set.
Quick-Switch
1" 1"
7/8"
7/8" x 8" radius
1" x 6" radius
Part No.
Standard Bendarc With Dies To: Bend 25mm/1" Tube to 203mm/8" Radius Bend 25mm/1" Tube to 250mm/10" Radius
C997 C995B
Bend 32mm/11/4 " Tube to 250mm/10" Radius
Custom order to your specification. Order one or several die sizes.
Crownarc Tube Bender
Part No.
Description
Pack Qty
G846S
25mm/1" Tube Adjuster
Pair
▲ Crownarc - The only crowner with gear drive. ▲ Mounted on the wall, a table or on the side or rear of a truck, Crownarc puts a crown onto tubing. ▲ Bends 19, 22 &25mm/ 3⁄4, 7⁄8 & 1 inch outside diameter tubing using the same dies. ▲ Dies and rollers are mounted on a backplate of boiler plate steel. ▲ Rollers are high density polymer. ▲ The center roller is fully adjustable.
1 Insert the uncrowned bow
NOTE: 2 pairs of G846S are needed to make a set.
Canvas Clip ▲ Helps to hold fabric on frame while patterning. ▲ One end can be used on 7⁄8 ", the other is for 1".
2 Crank it Thru
58
Part No.
Bends Tube Size
C998 C998/114
19, 22 & 25mm/ 3⁄4 , 7⁄8 & 1" Tubing 1 1/4" Tubing
Part No.
Description
Pack Qty
G380
Canvas Clip
50
East Phone: 1-781-821-2600 Fax: 1-781-821-2609