146
Ballast: Permitted.
GROUP 2
Batteries: All wet cell batteries must be isolated from driver compartment and must be securely mounted. Refer “Batteries” . Body: May use any coupe, sedan, station wagon, panelvan or utility derivative originally mass produced by any automobile manufacturer. Fenderless Hot Rod type vehicles, one piece bodies, Funny Car, Altered style bodies, open top or rear engine sports cars are not permitted. Fibreglass or composite bodies are permitted where all other requirements are met, factory steel bodies permitted. Original or replica headlight and taillight housings are required. All vehicles must have at least 2 operative doors that permit exit and/or entry from either side. Four door bodies may be converted to two door on approval. Body maybe lengthened or shortened equal to any wheelbase increase or decrease. Overall body height (roof to sill/rocker) may be reduced by up to 4 inches (100mm) from OEM. Overall minimum vehicle height, as measured from the ground to the highest point of the roof, must be no less than 45 inches (1143mm). Body width may be narrowed but may be no less than 63 inches (1600mm) at front axle and 68 inches (1727mm) at rear axle. Maximum rear overhang 70 inches (1778mm) beyond rear axle centreline. A bonnet is required on all cars in this class. Side panels may be omitted. One piece bonnet/guard assembly permitted. ◊ NOTE: Vehicles that comply with current Pro Stock style “spec” bodyregulations will be accepted in this section (see Refer Pro Stock, Body & Chassis). Bumpers: Optional. Fenders: Must have four production type fenders. Fibreglass or composite replicas permitted. One piece front clip permitted. Maximum permitted overhang 45 inches (1143mm). Frame: Frame from radiator to rear of car may be replaced. Refer “Frame & Chassis” . Radiator and Grille: Radiator optional. Grilles are required, and may be painted on. Spoilers: Permitted. Front airfoils prohibited. Street Equipment: Headlights must be original size in original location but may be painted on. Wheelbase: OEM vehicle wheelbases with less than 115 inches may be lengthened between OEM and 115 inches, OEM vehicle wheelbases with more than 115 inches may be shortened between OEM and 115 inches, Vehicles with OEM wheelbase above 115 inches must not exceed the OEM wheelbase