CARBIDE TIPPED LOCK MITER SET Tool No. 747 as shown up to 1” material. Tool No. 748 for 1/2” material with 1/8” wide tongue and groover. Tool No. 749 for 3/8” material with 3/32” wide tongue and groover.
No. A is run flat on shaper table. No. B is run one end against the shaper fence. Maximum width of material to be cut is 1”.
When properly positioned, this cutter set will cut No. A and No. B matching joints without changing the vertical adjustment of the cutter on the shaper.
CARBIDE TIPPED LOCK-MITER SET #757
Does not include groover. See groovers page 18. Stock A & B are run flat on the shaper table. Part “B” is run again on table saw to cut groove.
CARBIDE TIPPED REVERSIBLE GLUE JOINT CUTTERS (CUTTER SHOWN)
CARBIDE TIPPED EDGE BAND SHAPER CUTTER SET #759 Each set consist of 2 cutters. Style M and F. Separate cutters are available. See price list.
3/4” - 7/8” THICK MATERIAL
CARBIDE TIPPED DRAWER LOCK CUTTER #705
Run drawer face flat on the shaper table over the top of the cutter and run the drawer side on end against the shaper fence. FINISHED JOINT 1/2” SIDE DRAWER FRONT
STANDARD DIAMETERS 1/2” bore - 3-1/2 diameter 1-1/8” bore - 4” diameter 3/4” bore - 3-1/2 dimeter 1-1/4” bore - 4” diameter 1” bore - 4” diameter Other diameters are available.
DRAWER FRONT 1/2” SIDE
Standard diameters are for use with drawers using 1/2” thick drawer sides. For 3/4” drawer side material add 1/2” to standard diameter. If 1/2” side mounted drawers slides are used add 1” diameter.