1600 YRM 1133
Steering Axle Assembly Repair NOTE: Ensure that the washer is seated properly against the bearing cone and not against the shaft shoulder before tightening the castle nut. 3. Install the castle nut and tighten as follows for your lift truck: a. GLC20-35VX (GC/GLC040-070VX, GC/GLC055SVX) (A910) - Tighten the castle nut to 68 N•m (50 lbf ft) while rotating the wheel in both directions to properly seat the bearings. Loosen the castle nut 1/4 turn. Tighten nut to 3 N•m (27 lbf in). Pull on the wheel axially to ensure that there is no end play. If there is excessive end play, reassemble washer and repeat Step 1 through Step 3.
NOTE: RIGHT SIDE IS SHOWN 1. 2. 3. 4. 5. 6. 7. 8.
HUB ASSEMBLY HUB CAP COTTER PIN CASTLE NUT WASHER OUTER BEARING CUP AND CONE INNER BEARING CUP AND CONE SEAL
Figure 16. Bearing Arrangement for Lift Truck Models GLP/GDP60VX, GLP/GDP70VX (GP/GLP/GDP135VX, GP/GLP/GDP155VX) (C878, D878, E878) and GLP/GDP80VX, GLP/GDP80VX9, GLP/GDP90VX (GLP/GDP170VX, GLP/GDP170VX36, GLP/GDP190VX) (A909, B909)
b. GLP/GDP20-35VX (GP/GLP/GDP040-070VX) (B875) - Tighten the castle nut to 200 N•m (147.5 lbf ft) while rotating the wheel in both directions to properly seat the bearings. Loosen the castle nut until wheel turns freely with no end play. Tighten nut to 15 N•m (133 lbf in). c. GC/GLC030-035VX, GC/GLC040SVX (C809) - Tighten the castle nut to 200 N•m (147.5 lbf ft) while rotating the wheel in both directions to properly seat the bearings. Loosen the castle nut until wheel turns freely with no end play. Tighten nut to 12 N•m (106 lbf in). d. GLP/GDP16-18VX, GLP/GDP20SVX (GP/ GLP/GDP030-035VX, GP/GLP/GDP040SVX) (C810) - Tighten the castle nut to 200 N•m (147.5 lbf ft) while rotating the wheel in both directions to properly seat the bearings. Loosen the castle nut until wheel turns freely with no end play. Tighten nut to 12 N•m (106 lbf in).
17