2200 YRM 1128
AMPSEAL Crimping Tools
HOW TO USE AMP PRO-CRIMPER II TOOL
NOTE: Make sure neither wire barrel nor insulation barrel are damaged.
1. Strip insulation from wire. See Stripping Wire for Use With AMP PRO-CRIMPER II Tool procedure.
6. Hold contact in position and squeeze tool handles until ratchet engages enough to hold contact.
2. Hold PRO-CRIMPER II tool so BACK side (wire side) is facing you.
7. Insert stripped wire into contact insulation and wire barrels until butted against wire stop.
3. Squeeze tool handles together, then allow to fully open.
8. Squeeze tool handles, while holding wire in position, until ratchet releases.
4. Holding contact by mating end, insulation barrel first, insert contact through front of tool and into appropriate crimp section.
9. Allow tool handles to open and remove crimped contact from tool.
5. Mating end of contact should be on locator side of tool; the open "U" of wire barrel and insulation barrel should face the top of the tool. The contact to be placed to that movable locator drips into slot in the contact. Butt the front end of the wire barrel against locator.
10. Check crimp height as described in Crimp Height Inspection.
AMPSEAL Connector Assemblies DESCRIPTION FOR PLUG CONNECTOR ASSEMBLY The plug assembly consists of a housing, a wedge lock, a wire seal, and a mating seal. See Figure 41.
69