2200 YRM 1128
AMPSEAL Crimping Tools The locator assembly, on the outside of the frame, contains a locator, a spring retainer, and a contact support. The dies are secured to the frame with retaining pins and retaining screws. A nut on the upper retaining screw holds the locator assembly in place.
1. 2. 3. 4. 5.
BACK OF TOOL STRIPPED WIRE WIRE BARREL CONTACT LOCATOR Figure 34. Crimp Contact to Wire
NOTE: Make sure wire barrel is not deformed during crimping procedure. 5. Holding contact in this position, squeeze tool handles together. 6. Insert properly stripped wire through locator and into wire barrel of contact. 7. Crimp contact onto wire while holding wire in place by squeezing tool handles together until ratchet releases. 8. Allow tool handles to open fully and remove crimped contact from tool.
AMP PRO-CRIMPER II TOOL Description This tool has a tool frame with stationary jaw and handle, a moving jaw and handle, and an adjustable ratchet to ensure full contact crimping. The tool frame contains a die assembly with two crimping sections. The die assembly contains a wire anvil, an insulation anvil, a wire crimper and an insulation crimper. See Figure 35.
A. TOOL FRONT B. TOOL BACK 1. 2. 3. 4. 5. 6.
STATIONARY JAW STATIONARY HANDLE MOVING JAW MOVING HANDLE DIE ASSEMBLY LOCATOR ASSEMBLY Figure 35. AMP PRO-CRIMPER II Tool
Remove and Install Die Set and Locator Assembly NOTE: Perform Step 1 through Step 3 for removal of die set and locator assembly. Follow Step 4 through Step 12 for installation of die set and locator assembly. 1. Close tool handles until ratchet releases. 2. Remove nut, locator assembly, upper and lower die retaining screws, and upper and lower die retaining pins. See Figure 36. 3. Slide wire anvil, insulation anvil, wire crimper, and insulation crimper out of tool frame. See Figure 36.
65