100 YRM 1222
Painting Instructions
Painting Instructions WARNING Always wear protection equipment like: Gloves, goggles, face shield, safety glasses, and a mask if an electric sander or spraying paint either aerosol can or spray gun is used.
WARNING Always use solvents and paints in an area with ventilation. Do not use solvents or paints near heat, fire, or electrical equipment that can make sparks. Follow the manufacturer’s instructions and cautions. 1. Remove all dirt from the surface to be painted. Clean the area to be painted. Use a solvent for painted surfaces to remove grease and oil before sanding. Do not use solvent on new paint. Make sure all oil and grease is removed. 2. Use sandpaper to remove the top surface of the paint and rust from the metal. All metal surfaces where the paint is completely removed, must be painted. Use a primer. Apply the primer before applying the final coat of paint.
3. Protect all surfaces that will not be painted. See the list of items in Figure 17.
CAUTION Do not paint the pads, plastic covers or knobs, cables, labels, and information plates, or controls. Paint can make some assemblies not operate correctly. 4. Paint the surfaces. Use the correct paint from your dealer for Yale lift trucks. Follow the directions on the container. The correct arrangement of colors is shown in Figure 17.
WARNING Make sure all labels are installed after painting is complete. Safety labels are installed on the lift truck to give information about possible hazards. It is important that all safety labels are installed on the lift truck and can be read. 5. Check that all labels are installed in the correct locations on the lift truck. See Figure 18. New labels are available from your dealer for Yale lift trucks.
21