8200 SERIES-TRACTORS
Splitting - Intermediate housing / Centre housing 14. Remove suction pipe (1) (Fig. 1) from the Gerotor pump, and the elbow unions fitted in the intermediate housing and Full Powershift gearbox. 15. Remove the chassis reinforcements located either side of the Heavy Duty gearbox (if installed, see section 2F01). Remove clutch lube pipe (17) located between the intermediate housing (19) and spacer (16) (Fig. 2 - 2A) (Heavy Duty gearbox). 16. Disconnect the handbrake control cable above the intermediate housing and creeper-speed control on the right-hand side of the intermediate housing (depending on option, all tractor types). 17. Mark then disconnect: - the harness to the solenoid valves on the right-hand hydraulic cover, and the harness to the Park lock transmission lock located on the right-hand side of the intermediate housing (if the tractor is fitted with this device), - the harness to the low-pressure switch and the one to the clogging switch on the main filter (15 microns), - the harnesses to the load sensors, - the connectors to the (MoveUp-MoveDown) solenoid valves of the lift control valve, - the harnesses to the position sensors on the righthand lift bearing and the drive sensor on the centre housing, - the PTO sensors (dual driving pinion and output shaft) on the rear housing. 18. Block the front axle (1), using suitable chocks - "C" (depending on the type of front axle Dana - ZF 5052 or Carraro) (Fig. 3).
2D01.3
1
AG 250
AG 150
Fig. 1
Issue 2
May 2002