8200 SERIES-TRACTORS
Splitting - Intermediate housing / Centre housing 28. Remove housing attachment screws (2). Install guide studs of sufficient length then start the separation (Fig. 7). Note: In the event of resistance being felt during separation, screw two screws of suitable length into tapped holes "T" located on the right and left attachment flanges of intermediate housing (Fig. 6). Continue the extraction until the sumps are completely apart. Shaft (28) (Fig. 7) located between the drive bearing of the pumps and the PTO clutch comes out with the intermediate housing. efore setting down the shaft, if required visually mark land "D" to allow passage of the crown wheel (Fig. 7).
2D01.7
T
Fig. 6
C . Reassembling Assembling the intermediate housing and the centre housing 29. Clean the mating surfaces of the housings. 30. Coat the mating face of the centre housing with sealing product - Loctite 510 or equivalent. 31. Check for presence and position of locating pin (1) sleeve- itted into the centre housing (Fig. 7). Note: The stud has two flats positioned parallel with the centre line of the housing (Fig. 7). 32. If removed, reposition PTO shaft (28), checking the position of land "D" (Fig. 7). 33. Screw two guide studs at diametrically opposite positions on the centre housing. 34. Assemble the intermediate housing to the centre housing. Turn the pump driving pinion in order to mate the splines of shaft (28) with the splines on the PTO clutch. 35. Remove the guide studs. Install screws (2) and torque to 300 - 400 Nm. 36. Clean the mating surfaces of intermediate housing (19) and cover (3) (Fig. 7).
Issue 2
May 2002