Service Manual
Tools and work instructions Special tools
3
Special tools for in-house manufacture Note! The following dimensions are given in millimeters [mm].
3.1
Pin puller To pull the two pins from the cylinder bearing – telescopic cylinder 1 of the 13 m telescope. See also section 17.2 Repair instructions.
Fig. 1 Pin puller
1 2 3 4
Guide rod Hex fitting Impact sleeve Allen screw M8x30 8.8
5 Hex nut M20 6 Washer ISO 8738 20 7 2x Washer DIN 433 8,4
Note! Affix the hex nut Pos.5 with three weld points.
TL 435-10 TL 445-10 TL 435-13 TL 442-13
F/N xxx-6000 F/N xxx-6000 F/N xxx-6000 F/N xxx-6000
copyright by
MJFCIFSS!
2.1.000 - 13 / 14