Figure 10-110-4
ENGINE LUBRICATION SYSTEM (CONT’D) Replacing Oil And Filter (Cont’d)
WARNING Always clean up spilled fuel or oil. Keep heat, flames, sparks or lighted tobacco away from fuel and oil. Failure to use care around combustibles can cause explosion or fire which can result in injury or death.
1
W-2103-1285
Figure 10-110-3
P-28804
Remove the fill cap (Item 1) [Figure 10-110-4]. Put oil in the engine. (See Capacities on Page SPEC-105.) [Figure 10-110-4] (See Oil Chart on Page 10-110-1.) 1
Start the engine and let it run for several minutes. Stop the engine and check for leaks at the oil filter. Remove the dipstick and check the oil level. Figure 10-110-5 P-43238
Remove the oil filter (Item 1) [Figure 10-110-3].
1
Clean the filter housing surface. Put clean oil on the new oil filter gasket. Install the filter and hand tighten. Install and tighten the drain plug.
P-1575
Add oil as needed if it is not at the top mark (Item 1) [Figure 10-110-5] on the dipstick. Install the dipstick and close the rear door.
10-110-2
753 Bobcat Loader Service Manual