MD0277
MD0275
! CAUTION To prevent damage to the crankshaft, install a protective insert into the end of the crankshaft. The puller must bottom on the insert and not on the crankshaft. Also, do not thread puller bolts more than five threads into the flywheel. Damage to the stator coils may result.
8. Install Flywheel Puller Insert (p/n 0644-179) into the end of the crankshaft. Using Flywheel Puller/ Spanner Wrench (p/n 0144-310) or suitable substitute, remove the flywheel.
MD0067
10. Remove the rubber insulator grommet from the crankcase; then remove two Phillips-head cap screws securing the ignition timing sensor and pull the wires through the hole in the crankcase.
AN615
„ NOTE: To ensure the cleanliness of the flywheel magnets, place the flywheel (with the magnets facing upward) on a clean bench. 9. Remove the six cap screws securing the rear (intake-side) shroud; then remove the shroud. Account for the special washers.
MD0075
2-42