PERIODIC MAINTENANCE 2-29 Periodic Maintenance Procedures Engine Lubrication System Engine Oil Change
the motorcycle so that it is vertical after warming • Situate up the engine. the engine drain plug [A] to drain the oil. •○Remove The oil in the oil filter can be drained by removing the filter
•
(see Oil Filter Change). Replace the drain plug gasket [B] with a new one if it is damaged. Tighten the drain plug. Torque - Engine Drain Plug: 20 N·m (2.0 kgf·m, 14.5 ft·lb)
• Pour in the specified type and amount of oil. Engine Oil Grade:
API SE, SF or SG API SH or SJ with JASO MA Viscosity: SAE 10W–40 Amount: 3.1 L (3.3 US qt) (when filter is not removed) 3.3 L (3.5 US qt) (when filter is removed) 3.8 L (4.0 US qt) (when engine is completely dry)
NOTE
○Depending on the atmospheric temperature of your riding area, the engine oil viscosity should be changed according to the chart.
Oil Filter Change
the engine oil (see Engine Oil Change). • Drain • Remove: Lower Fairing (see Frame chapter) Remove the oil filter [A] with the oil filter wrench [B]. • Special Tool - Oil Filter Wrench: 57001–1249
the filter with a new one. • Replace engine oil to the gasket [A] before installation. • Apply Tighten the filter with the oil filter wrench. •
Torque - Oil Filter (P/No. 16097–1070): 27 N·m (2.8 kgf·m, 20 ft·lb) Oil Filter (P/No. 16097–0002): 31 N·m (3.2 kgf·m, 23 ft·lb)
NOTE
○Hand tightening of the oil filter can not be allowed since it does not reach to this tightening torque.
in the specified type and amount of oil (see Engine • Pour Oil Change).